Laboratories

Point Contact Coefficient of Friction Test

Source:Labthink  Viewer:1485   Issuing Date:2011-01-21
Abstract:Point Contact Coefficient of Friction Test
Keywords: Coefficient of Friction Test

1. User Requirements:
Metal material slides on the surface of the film specimen, and measure the coefficient of friction between the two materials. The contact between film and metal materials is point contact.

2. Relevant Standards
As per GB 10006 Plastics – Film and Sheeting – Determination of the Coefficients of Friction

3. Testing Principle
Beset three steel balls under the sled with regulated weight. The three steel balls form a surface, and can not turn around. Place the sled onto the specimen. The sled contacts the film through the three balls.

4. Testing Procedure
Beset the three steel balls firmly on the same side of the sled, and make sure the highest points of them all of the same height. When testing, place the film specimen onto the bench and then, place the sled onto the specimen. Pull the sled for rectilinear motion with a uniform speed. Measure the change of force values on the sensor to obtain testing results, as in Fig. 1.

dianjiechu01en.gif
Fig 1 Structural Drawing of Test

5. Conclusion
Through testing, demands can be satisfied.

Relating Articles

Member Registration and Login In

   If you are already a member of us, please login in!    If you are not a member of us, please register for free!


·Forget password?
  • Username
  • Password
  • Verification Verification:


·Terms and Conditions

If you have questions,
please phone
86-531-85811021
  • Username *
  • Password *
  • Re-enter Password *
  • TrueName *
  • E-mail *
  • Cellphone *
  • Company *
  • Title *
  • Address *
  • Post Code  
  • Telephone *
  • Fax  
  • Website